Clean the splines on the input shaft and install the clutch disc. Also replace it if the stem end the surface contacting the hydraulic-lash adjuster ishollowed out. Measure the voltage for the Refer to 1. If the resistance value is not as shown in the table, replace the temperature sender. Install the cable to the guide assembly.
It mates well to the new six-speed manual gearbox, which offers positive shifts and helps keep the V-6 in its powerband. Check the rubber parts for damage or deterioration. Out of the pool of available performance parts, we have narrowed down to the best parts available. Remove the transaxle side cover. Check the battery installed in the vehicle to ensure that it is in good condition. Using a cutter knife or the special tool 09861-31200 , scrape the old sealant smoothly to a thickness of about 2 mm 0. Attach the wiring harnesses with clamps so that there is no slack.
Firmly insert the oil level gauge into the oil filler tube. Jack up the vehicle and support it with jack stands. Install the upper and lower timing belt covers. If not, make the following adjustment. After loosing the sub frame mounting bolts a little so as to be the sub frame assembly hung down slightly.
Remove the head lamp relay from the relay box in the engine compartment. Recommended grease : Sunlight No. Remove the snap pin of the select cable. Install the tab washer and the tie rod and stake the tab washer end at two points over the tie rod. Remove the main crash pad.
Tightening torque: 9~14 Nm 90~140 kg·cm, 6. So voltage is not supplied to each solenoid valve, brake fluid passes through the inlet valve to wheel cylinder, resulting in pressure increase. Oil level must be up to fill the hole, add oil until it runs over. Loosen the rear bumper lower part mounting screws. Connect the negative battery cable. After installation, check that the driveshaft cannot be removed by hand.
Test gear humming, we warmed up the race-car's slick tires and laid down the quickest 0-60-mph time we've ever recorded for a front-drive car at 5. If the clutch needs adjustment, increase or decrease the number and thickness of shims as necessary, then reinstall the pressure plate, and recheck its clearance. The sound system does, too. Remove the birfield joint boot bands and pull out the double offset joint boot and birfield joint boot. Install the belt in the fllowing order. Install the camshafts after lubricating the journals of the camshaft with engine oil.
Last stage : Canvas on the load side of the tooth flank worn down and rubber exposed tooth width reduced. Purchase used Hyundai Tiburon engines from dependable salvage yards network that offers up to 3-year warranty and free freight! Remove the transaxle mounting bracket. Remove the wheel speed sensor and the knuckle mounting bolt. Using a micrometer, measure the disc thickness at eight positions approximately 10mm from the outer edge of the disc and at 45° intervals. Remove the front roll stopper. Hone the cylinders, finishing them to the proper dimension piston outside diameter + gap with cylinder. Ask what it feels like, what it sounds like, etc.
Remove the speedometer driven gear connector. More error codes than two 4. The steering wheel mounting nut, and remove the steering wheel. Using the special tool 09222-28000, 09222-28100 , compress the spring and install the retainer locks. If the steering continues to pull to the opposite side, replace the front wheels with new ones.