In a place that's almost impossible to find: screwed to the side of the car under the dash on the driver's side. Could be done by the average person. In the 2008-2011 Ford F150 the blower motor resistor is also located behind the glove box, but is installed in the right side of the plastic air duct. I don't recommend removing this, I did and it resulted in a strong smell of gas every time I fill… There is a five-pin connector near the blower motor on the front passenger side of the vehicle between the blower motor and the firewall. The glove box will swing out when you remove these screws. Remove the glove box and look way back under the air box Answer: Just had to look for mine today. This happens often in many cars.
This 92 honda accord fuse box picture has been authored. Pull it out and clean the surfaces. Remove the clip with the wire harness, then install…. You need a socket and much patience to remove it. A tell-tale sign of a damaged resistor is the absence of blower motor sound. One of the symptoms of a worn out blower motor is that it can intermittently produce a loud screeching noise when running. Continue reading to bring some cool air into your Honda Civic.
Easier said than done in may cases. If the fuse is good,check to see if there is voltage to the blower motor,if there is,replace the blower motor. Remove three screws holding blower assembly in place. I checked the fuses and they all seem fine as well. It can only go in one way. After you have removed the screws pull down on the shroud and look on the right hand side as you are facing the front of t … he truck.
Make sure you get the information you are looking for. A blower motor resistor is a simple electric resistor. What controls your auto's fan speed and air conditioning settings is your blower motor resistor. For more information go to. In no way does workingtools. I thought it could have been a bad knob at first, but that's been checked and it's fine. Do not forget to share and love our reference to help further develop our website.
That is why it's better to know than not to know. It would help if you told us what model Buick this is. Use the Phillips screwdriver to remove four screws holding the glove box frame in place. Hope this is at least helpful. I 've got an Accord with the same problem.
Mechanically it runs as good as it did 16 years ago, but I'm starting to wonder if it's worth it anymore, as everything else is starting to go. Then you will see a flat silvery box, this is the power steering box. Maybe one or more of your. The legs I am refuring to,are the prongs on the relay. I had to replace the blower motor at about 110,000 miles. If the relay clicks and turns the fan on,when you touch the right one,then the fan,and the relay are good,it will be the blower fan switch.
There is one plug for each connection that you must unplug. . After removing the nuts, remove the bracket. It should have several wipers and the resistor itself protrudes downward into the box held in place with two screws. Then remove the three blower housing retaining nuts, pull the blower housing out far enough to unplug the electrical connectors at the lower right edge, right above the kick panel and remove the blower assembly housing.
The wheels, from heat and cold over many years, become very set on the blower rod. If a blower motor is bad, it will need to be replaced. If this is the case with your Honda Accord, then better find a blower replacement immediately. Dec 20, 2009 I had the same problem. If they are good, remove the blower motor relay and use a testlight to check fot power at the relay socket two of the recepticals in the socket should have batery voltage---the other two should not. Its held in w … ith 2 8mm bolts.